On 10/6/06, Drew Weaver <drew.weaver at thenap.com> wrote: > FC5 doesn't install without command line arguments either. > > Thanks for the suggestion, > In that case, I would find out if you need BIOS updates. Most of the boxes I saw that needed those command line options needed a BIOS update. > -Drew > > -----Original Message----- > From: centos-bounces at centos.org [mailto:centos-bounces at centos.org] On > Behalf Of Joshua Baker-LePain > Sent: Friday, October 06, 2006 3:50 PM > To: CentOS mailing list > Subject: RE: [CentOS] 2.6.18 Kernel > > On Fri, 6 Oct 2006 at 3:30pm, Drew Weaver wrote > > > So you're the one guy that got it working? > > > > In order for me to even get the installer to boot on a DG965ss I have > > to pass these commands to the kernel: > > > > pci = nommconf acpi=off irqprobe all-generic-ide > > > > If I do all of that it will install, but it has no idea what any of > > the devices are. > > In this order, I'd: > > 1) Make sure you're installing 4.4 (rather than a previous point > release. > > 2) Run FC5 (or 6, due out next week) until CentOS 4.5 is out, which will > likely improve support for those chipsets. > > -- > Joshua Baker-LePain > Department of Biomedical Engineering > Duke University > _______________________________________________ > CentOS mailing list > CentOS at centos.org > http://lists.centos.org/mailman/listinfo/centos > _______________________________________________ > CentOS mailing list > CentOS at centos.org > http://lists.centos.org/mailman/listinfo/centos > -- Stephen J Smoogen. -- CSIRT/Linux System Administrator How far that little candle throws his beams! So shines a good deed in a naughty world. = Shakespeare. "The Merchant of Venice"