[CentOS] Question about centos 4 or 5 install with software RAID
Mogens Kjaer
mk at crc.dkFri Aug 31 06:23:35 UTC 2007
- Previous message: [CentOS] Question about centos 4 or 5 install with software RAID
- Next message: [CentOS] strange chgrp behavior
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Jerry Geis wrote: > When doing software RAID-1 installs on reboot (just after install) > I ALWAYS get RAID device is not clear - preforming reconstruction. > > Why is this? If I just installed the array should be in sync shouldnt it? > And clean? No, the syncing could take a couple of hours, depending upon the sizes of your arrays. This takes place during the installation. If the syncing hasn't finished before the installation has finished, it will have to continue after the reboot. I don't know if it is smart enough to continue where it stopped, or it has to start all over? Mogens -- Mogens Kjaer, Carlsberg A/S, Computer Department Gamle Carlsberg Vej 10, DK-2500 Valby, Denmark Phone: +45 33 27 53 25, Fax: +45 33 27 47 08 Email: mk at crc.dk Homepage: http://www.crc.dk
- Previous message: [CentOS] Question about centos 4 or 5 install with software RAID
- Next message: [CentOS] strange chgrp behavior
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
More information about the CentOS mailing list