Christian Nygaard wrote: > I'm considering how to design a new file server with a 3ware 9650se RAID > controller. How much > would you estimate the impact to be on sharing /home and the operating > system on one raid 6 set? > /home is mostly read only accesses with a ratio 10:1 read/write. I'm a > little bit concerned that the log writes > in /var/log could impact read performance on /home causing disk head > movements or that a little/non issue with > modern Raid controllers? > > What would give best performance > Scenario 1 > 8*500G Raid 6 /home and operating system > > Scenario 2 > 6*500GB Raid 6 /home > 2*250GB Raid 1 operating system > > Looking for feedback Carving up a hardware device into partitions results in a performance penalty that goes up to 30%. eg: A single /dev/sda will perform better than if it were carved in /dev/sda1 /dev/sda2. I am not sure how a single /dev/sda used as a physical volume which is then carved logically performs however. So my suggestion would be 6*500GB Raid6 /home and 2*250GB raid 1 operating system (remember, if the mirror is carved up, you will receive a performance penalty). The performance penalty is incurred regardless of what I/O patterns a particular partition has so your concern about log writes to /var/log affecting /home are correct but not just due to the writes...the writes merely affect the degree of the performance penalty. This was verified with SCSI disks, ATA disks and 3ware arrays but it was a while ago. Perhaps things have changed in the latest kernels but with Centos 4.4 at 2.6.9 I don't think Centos 4 kernels have those changes if they exist.