try 8139too On Tue, 2007-10-23 at 20:22 -0200, Linux Man wrote: > Well, with lspci, the two NIC's are Realtek Semiconductor Co., Ltd. > RTL-28139/8139C/8139C+ (rev 10) and ADMtek NC100 Network Everywhere > Fast Ethernet 10/100 (rev 11), how can I know the kernel modules > asociated? > Thanks! > > > 2007/10/23, Alain Spineux <aspineux at gmail.com>: > > Look in your fedora fc1 or knoppix witch module was loaded for your two nic. > > Then try a > > # modprobe <your_module_name_here> > > then > > # dmesg > > to look if both nics where recognized. > > If so you have to update your modprobe.conf > > > > Alain > > > > Regards > > > > > > > > On 10/22/07, Linux Man <linuxman.uru at gmail.com> wrote: > > > I'm building a Linux box to act as Proxy/Router/Firewall. > > > I'm using CentOS 4.5, with an "old" motherboard (Asus A8V-X), and two > > > Ethernet NIC, based on a realtek chip, that's widely supported under > > > 2.4 and later kernel (the cards were functioning excellent in another > > > PC whit Fedora Core 1). > > > CentOS detects the on board LAN, but not the other two, in fact, > > > knoppix 5.0.1 doesn't detect too (kernel 2.6.17), but, Knoppix 5.1.1 > > > (kernel 2.6.19) detects all three cards. > > > Do you have any idea why this behavior? > > > Centos 5.0 detects all three too, but I don't now why, my firewall > > > script (ipv4) doesn't work with this release. > > > > > > Now, thank you very much! -- Craig White <craig at tobyhouse.com>