Well, with lspci, the two NIC's are Realtek Semiconductor Co., Ltd. RTL-28139/8139C/8139C+ (rev 10) and ADMtek NC100 Network Everywhere Fast Ethernet 10/100 (rev 11), how can I know the kernel modules asociated? Thanks! 2007/10/23, Alain Spineux <aspineux at gmail.com>: > Look in your fedora fc1 or knoppix witch module was loaded for your two nic. > Then try a > # modprobe <your_module_name_here> > then > # dmesg > to look if both nics where recognized. > If so you have to update your modprobe.conf > > Alain > > Regards > > > > On 10/22/07, Linux Man <linuxman.uru at gmail.com> wrote: > > I'm building a Linux box to act as Proxy/Router/Firewall. > > I'm using CentOS 4.5, with an "old" motherboard (Asus A8V-X), and two > > Ethernet NIC, based on a realtek chip, that's widely supported under > > 2.4 and later kernel (the cards were functioning excellent in another > > PC whit Fedora Core 1). > > CentOS detects the on board LAN, but not the other two, in fact, > > knoppix 5.0.1 doesn't detect too (kernel 2.6.17), but, Knoppix 5.1.1 > > (kernel 2.6.19) detects all three cards. > > Do you have any idea why this behavior? > > Centos 5.0 detects all three too, but I don't now why, my firewall > > script (ipv4) doesn't work with this release. > > > > Now, thank you very much! > > Best Regards. > > _______________________________________________ > > CentOS mailing list > > CentOS at centos.org > > http://lists.centos.org/mailman/listinfo/centos > > > > > -- > Alain Spineux > aspineux gmail com > May the sources be with you > _______________________________________________ > CentOS mailing list > CentOS at centos.org > http://lists.centos.org/mailman/listinfo/centos >