On Fri, 2008-04-11 at 19:45 -0500, Les Mikesell wrote: > Timothy Selivanow wrote: > > On Fri, 2008-04-11 at 17:23 -0400, Ross S. W. Walker wrote: > > > >> This should give you what you need when doing 802.3ad LAGs: > >> > >> interface FastEthernet0/21 > >> port group 1 > >> spanning-tree portfast > >> ! > >> interface FastEthernet0/22 > >> port group 1 > >> spanning-tree portfast > >> ! > > > > Using this on the switch and mode=4 for bonding results in the machine > > not being able to contact anything (happens with just 'port group 1' > > too, I tried that a "long" time ago), but there aren't any errors. So, > > it doesn't work, but I couldn't tell you why. Is there anything else > > that needs to be done, perhaps on the host's side? > > Does the same thing happen if you only connect one interface? I was > under the impression that a single member of a group would work the same > way as a normal interface. Also does it help to add 'distribution > destination'? Have you tried Port Group 2 - 8. Hardware Failing? Those are the right commands for it as I found in the cisco docs. > -- ~/john OpenPGP Sig:BA91F079