Jerry Geis wrote: > I have 2 questions dealing with 2 different kickstart files. > > 1) my kickstart sections for RAID disk setup and kickstart reports it > cannot find sda. Why is that. sda is there and works. > > clearpart --all --initlabel > part raid.01 --asprimary --bytes-per-inode=4096 --fstype="raid" > --onpart=sda1 --size=20000 I've had issues with onpart in the past. I had to use ondisk and trust the anaconda to put the partitions in a good place. > > 2) my kickstart section for normally single disk setup. However with 2 > disks present in box > it put / on sda and /home on sdb. Is there a way to put it ALL on sda??? > If there is a second disk I want it left alone. > > clearpart --all --initlabel > part / --fstype ext3 --size=20000 --asprimary > part swap --size=4000 --asprimary > part /home --fstype ext3 --size=100 --grow --asprimary Use --ondisk to specify which disk. Also, if there is a 2nd disk, it will lose it's partition table because of your clearpart. You may want ot explore an ignoredisk command. -- Milton Calnek BSc, A/Slt(Ret.) milton at calnek.com 306-717-8737 -- This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean.