On 11/06/2009 09:04 AM, Steve Campbell wrote: > I'm running a server with Centos 3 that I have set up a smbfs share to a > Buffalo LinkStation. The LS has 4 drives configured with RAID 5. Each > disk has 1 TB capacity, so the resulting drive is approximately 2.7 TB. > > When doing a df, the result shows 2 TB, and no used blocks. Is there > some setting I can change so that Centos sees and uses all 2.7 TB or > does Centos 3 not support this? > > Steve Campbell > > _______________________________________________ > CentOS mailing list > CentOS at centos.org > http://lists.centos.org/mailman/listinfo/centos > Setting the blocksize did the trick for me. block size = 4096 This goes in the "services" section, not global. i.e.: [xx-01] comment = xx-01 path = /data-store valid users = xx read only = No block size = 4096 Hope this helps. Monty