Monty Shinn wrote: > On 11/06/2009 09:04 AM, Steve Campbell wrote: > >> I'm running a server with Centos 3 that I have set up a smbfs share to a >> Buffalo LinkStation. The LS has 4 drives configured with RAID 5. Each >> disk has 1 TB capacity, so the resulting drive is approximately 2.7 TB. >> >> When doing a df, the result shows 2 TB, and no used blocks. Is there >> some setting I can change so that Centos sees and uses all 2.7 TB or >> does Centos 3 not support this? >> >> Steve Campbell >> >> _______________________________________________ >> CentOS mailing list >> CentOS at centos.org >> http://lists.centos.org/mailman/listinfo/centos >> >> > > Setting the blocksize did the trick for me. > > block size = 4096 > > This goes in the "services" section, not global. > > i.e.: > > [xx-01] > comment = xx-01 > path = /data-store > valid users = xx > read only = No > block size = 4096 > > Hope this helps. > > Monty > > > I had googled and found something about that setting, but.... Where exactly is this set? What file is that set in? Thanks for the fast reply. steve