On Sat, Oct 31, 2009 at 12:37 AM, Lee Perez <leecajun at windstream.net> wrote: > Hi All, > > Quick question, I just finished googling and found the thread that is > dealing with the rpmdup_remover.sh script, and thanks to everyone that > was involved in this. I followed the following threads: > http://www.opensubscriber.com/message/centos@centos.org/11086209.html > http://www.centos.org/modules/newbb/viewtopic.php?viewmode=flat&topic_id=17166&forum=37 > > Which lead me to the following link and the script: > > http://www.centos.org/modules/newbb/viewtopic.php?topic_id=10139&forum=27&post_id=32527 > > I started an update at about 5pm on the 30th and here it is 2:30 in the > morning on the 31st. I want to kill this update and start over. I > usually get around 155 KB/s now I'm getting 455 B/s. I do believe it is > the mirror that I am connected to. I just want to make sure that by > using the above mentioned script that I am going the right way. > > Just looking for a little reassurance before I do it. If I don't I > don't think this thing will finish until sometime next week :-) and > that is a bit long. If you are still in the middle of downloading, it should be safe tostop it. Try Control-C once and see if you get to a faster mirror. Do the second Control-C to stop the transfer entirely. The script you referred to will work if a yum session gets interrupted and you end up with duplicates. Otherwise, you can try yum-complete-transaction (included in yum-utils) to ... er ... complete transactions. Akemi / toracat