Getting "bnx2i: iSCSI not supported, dev=eth0" for all the NIC adapters on all of my R710's running CentOS 5.5. Here is an sample of the error messages: bonding: Warning: either miimon or arp_interval and arp_ip_target module parameters must be specified, otherwise bonding will not detect link failures! see bonding.txt for details. bonding: bond0: setting mode to active-backup (1). bonding: bond0: Setting MII monitoring interval to 500. ADDRCONF(NETDEV_UP): bond0: link is not ready bonding: bond0: Adding slave eth0. bnx2: eth0: using MSIX bnx2i: iSCSI not supported, dev=eth0 bonding: bond0: enslaving eth0 as a backup interface with a down link. bnx2i: iSCSI not supported, dev=eth0 bonding: bond0: Adding slave eth2. bnx2: eth2: using MSIX bnx2i: iSCSI not supported, dev=eth2 bnx2: eth0 NIC Copper Link is Up, 1000 Mbps full duplex bonding: bond0: enslaving eth2 as a backup interface with a down link. bnx2i: iSCSI not supported, dev=eth2 bonding: bond0: link status definitely up for interface eth0. bonding: bond0: making interface eth0 the new active one. bonding: bond0: first active interface up! bonding: bond0: link status definitely up for interface eth2. ADDRCONF(NETDEV_CHANGE): bond0: link becomes ready bonding: bond0: link status definitely down for interface eth2, disabling it bnx2: eth2 NIC Copper Link is Up, 1000 Mbps full duplex bonding: bond0: link status definitely up for interface eth2. bond0: no IPv6 routers present Understanding that bnx2i is used for hardware iscsi, why is this error occurring? David