On 19 August 2010 20:39, David <david at adurotec.com> wrote: > Getting "bnx2i: iSCSI not supported, dev=eth0" for all the NIC adapters > on all of my R710's running CentOS 5.5. > > Here is an sample of the error messages: > > bonding: Warning: either miimon or arp_interval and arp_ip_target module > parameters must be specified, otherwise bonding will not detect link > failures! see bonding.txt for details. > bonding: bond0: setting mode to active-backup (1). > bonding: bond0: Setting MII monitoring interval to 500. > ADDRCONF(NETDEV_UP): bond0: link is not ready > bonding: bond0: Adding slave eth0. > bnx2: eth0: using MSIX > bnx2i: iSCSI not supported, dev=eth0 > bonding: bond0: enslaving eth0 as a backup interface with a down link. > bnx2i: iSCSI not supported, dev=eth0 > bonding: bond0: Adding slave eth2. > bnx2: eth2: using MSIX > bnx2i: iSCSI not supported, dev=eth2 > bnx2: eth0 NIC Copper Link is Up, 1000 Mbps full duplex > bonding: bond0: enslaving eth2 as a backup interface with a down link. > bnx2i: iSCSI not supported, dev=eth2 > bonding: bond0: link status definitely up for interface eth0. > bonding: bond0: making interface eth0 the new active one. > bonding: bond0: first active interface up! > bonding: bond0: link status definitely up for interface eth2. > ADDRCONF(NETDEV_CHANGE): bond0: link becomes ready > bonding: bond0: link status definitely down for interface eth2, disabling it > bnx2: eth2 NIC Copper Link is Up, 1000 Mbps full duplex > bonding: bond0: link status definitely up for interface eth2. > bond0: no IPv6 routers present > > > Understanding that bnx2i is used for hardware iscsi, why is this error > occurring? > > David > _______________________________________________ > CentOS mailing list > CentOS at centos.org > http://lists.centos.org/mailman/listinfo/centos > This was asked 2 or 3 days ago ... it refers to hardware offloading isn't supported I believe.