Jacob Hydeman wrote on Mon, 11 Jan 2010 10:50:17 -0800: > I've setup just the IPADDR= and NETMASK= to have different static IPs in > different subnets and changed to the BOOTPROTO=static in each of the > ifcfg-brX scripts. > > This hasn't fixed my issue. Perhaps it's because of the way I'm trying to > use it (or I don't get it). Does each VM that is using a specific bridged > device need to have the same IP subnet as that of the static brX address? No. But you have to tell via config (I don't know how KVM does this) which bridge the VM is going to use. And if you want it to be reachable via two bridges you have to set it up for two bridges and give it two IP numbers. And the packet then has to come in thru the correct interface/bridge, there is no "bridging" between the bridges. You would need to set up some additional routing to work around this (probably, I'm not a routing expert). Is that possibly not the case? e.g. your VMs are still setup to use only one bridge? Kai -- Get your web at Conactive Internet Services: http://www.conactive.com