[CentOS] bridge

Fri Sep 3 09:54:15 UTC 2010
Timo Schoeler <timo.schoeler at riscworks.net>

> In the host

Could you post you appropriate ifcfg scripts?

> -----Original Message-----
> From: centos-bounces at centos.org [mailto:centos-bounces at centos.org] On
> Behalf Of Timo Schoeler
> Sent: Friday, September 03, 2010 11:50 AM
> To: CentOS mailing list
> Subject: Re: [CentOS] bridge
>
>
>> For example
>> 2.6.18-194.8.1.el5.028stab070.4
>>
>> This is the openvz kernel
>
> True. So, where do you place the bridge, in the VE or in the host
> itself?
>
> Timo
>
>> -----Original Message-----
>> From: centos-bounces at centos.org [mailto:centos-bounces at centos.org] On
>> Behalf Of Timo Schoeler
>> Sent: Friday, September 03, 2010 11:43 AM
>> To: CentOS mailing list
>> Subject: Re: [CentOS] bridge
>>
>>
>>> I try to use a bridge with openvz but get the following Bridging
>>> Support is not available in this kernel This message are in all
>>> kernels i tryed from the centos yum repo On a frech 5.5 It has worked
>
>>> before With the same  install i have used
>>
>> Hi,
>>
>> so, you installed a fresh CentOS 5.5 and then added the OpenVZ repo
>> from
>>
>> their site?
>>
>> Which kernel did you try (of which you say it lacks bridge support)?
>>
>> Regards,
>>
>> Timo