[CentOS] bridge

Fri Sep 3 09:59:13 UTC 2010
mattias <mj at mjw.se>

Ifcfg-eth1
 

# Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+

DEVICE=eth1

 

HWADDR=00:50:FC:F9:84:CB

ONBOOT=yes

DHCP_HOSTNAME=vps.mjw.se

BRIDGE=br0

Ifcfg-br0
[br0]

ONBOOT=yes

TYPE=Bridge

BOOTPROTO=dhcp

-----Original Message-----
From: centos-bounces at centos.org [mailto:centos-bounces at centos.org] On
Behalf Of Timo Schoeler
Sent: Friday, September 03, 2010 11:54 AM
To: CentOS mailing list
Subject: Re: [CentOS] bridge


> In the host

Could you post you appropriate ifcfg scripts?

> -----Original Message-----
> From: centos-bounces at centos.org [mailto:centos-bounces at centos.org] On 
> Behalf Of Timo Schoeler
> Sent: Friday, September 03, 2010 11:50 AM
> To: CentOS mailing list
> Subject: Re: [CentOS] bridge
>
>
>> For example
>> 2.6.18-194.8.1.el5.028stab070.4
>>
>> This is the openvz kernel
>
> True. So, where do you place the bridge, in the VE or in the host 
> itself?
>
> Timo
>
>> -----Original Message-----
>> From: centos-bounces at centos.org [mailto:centos-bounces at centos.org] On

>> Behalf Of Timo Schoeler
>> Sent: Friday, September 03, 2010 11:43 AM
>> To: CentOS mailing list
>> Subject: Re: [CentOS] bridge
>>
>>
>>> I try to use a bridge with openvz but get the following Bridging 
>>> Support is not available in this kernel This message are in all 
>>> kernels i tryed from the centos yum repo On a frech 5.5 It has 
>>> worked
>
>>> before With the same  install i have used
>>
>> Hi,
>>
>> so, you installed a fresh CentOS 5.5 and then added the OpenVZ repo 
>> from
>>
>> their site?
>>
>> Which kernel did you try (of which you say it lacks bridge support)?
>>
>> Regards,
>>
>> Timo
_______________________________________________
CentOS mailing list
CentOS at centos.org http://lists.centos.org/mailman/listinfo/centos