In the host -----Original Message----- From: centos-bounces at centos.org [mailto:centos-bounces at centos.org] On Behalf Of Timo Schoeler Sent: Friday, September 03, 2010 11:50 AM To: CentOS mailing list Subject: Re: [CentOS] bridge > For example > 2.6.18-194.8.1.el5.028stab070.4 > > This is the openvz kernel True. So, where do you place the bridge, in the VE or in the host itself? Timo > -----Original Message----- > From: centos-bounces at centos.org [mailto:centos-bounces at centos.org] On > Behalf Of Timo Schoeler > Sent: Friday, September 03, 2010 11:43 AM > To: CentOS mailing list > Subject: Re: [CentOS] bridge > > >> I try to use a bridge with openvz but get the following Bridging >> Support is not available in this kernel This message are in all >> kernels i tryed from the centos yum repo On a frech 5.5 It has worked >> before With the same install i have used > > Hi, > > so, you installed a fresh CentOS 5.5 and then added the OpenVZ repo > from > > their site? > > Which kernel did you try (of which you say it lacks bridge support)? > > Regards, > > Timo _______________________________________________ CentOS mailing list CentOS at centos.org http://lists.centos.org/mailman/listinfo/centos