> In the host Could you post you appropriate ifcfg scripts? > -----Original Message----- > From: centos-bounces at centos.org [mailto:centos-bounces at centos.org] On > Behalf Of Timo Schoeler > Sent: Friday, September 03, 2010 11:50 AM > To: CentOS mailing list > Subject: Re: [CentOS] bridge > > >> For example >> 2.6.18-194.8.1.el5.028stab070.4 >> >> This is the openvz kernel > > True. So, where do you place the bridge, in the VE or in the host > itself? > > Timo > >> -----Original Message----- >> From: centos-bounces at centos.org [mailto:centos-bounces at centos.org] On >> Behalf Of Timo Schoeler >> Sent: Friday, September 03, 2010 11:43 AM >> To: CentOS mailing list >> Subject: Re: [CentOS] bridge >> >> >>> I try to use a bridge with openvz but get the following Bridging >>> Support is not available in this kernel This message are in all >>> kernels i tryed from the centos yum repo On a frech 5.5 It has worked > >>> before With the same install i have used >> >> Hi, >> >> so, you installed a fresh CentOS 5.5 and then added the OpenVZ repo >> from >> >> their site? >> >> Which kernel did you try (of which you say it lacks bridge support)? >> >> Regards, >> >> Timo