Em 17-06-2014 19:54, Nick Niemeyer escreveu: > # modinfo ixgbe > filename: > /lib/modules/2.6.32-431.el6.x86_64/kernel/drivers/net/ixgbe/ixgbe.ko > version: 3.15.1-k > license: GPL > description: Intel(R) 10 Gigabit PCI Express Network Driver > author: Intel Corporation, <linux.nics at intel.com> > srcversion: B390E9D9904338B52C2E361 > > I have updated this to 3.18.7-1 as well, same results > > # ifconfig bond1 |grep error > RX packets:4476995 errors:6940 dropped:0 overruns:0 frame:6940 > TX packets:2130564 errors:0 dropped:0 overruns:0 carrier:0 Frame errors are usually cable error and/or alike but can also be a result of mis-communication between driver/NIC firmware. What does 'ethtool -S' for each slave interface give you? Marcelo > # cat /proc/net/bonding/bond1 > Ethernet Channel Bonding Driver: v3.6.0 (September 26, 2009) > > Bonding Mode: adaptive load balancing > Primary Slave: None > Currently Active Slave: p6p1 > MII Status: up > MII Polling Interval (ms): 100 > Up Delay (ms): 0 > Down Delay (ms): 0 > > Slave Interface: p6p1 > MII Status: up > Speed: 10000 Mbps > Duplex: full > Link Failure Count: 0 > Permanent HW addr: 90:e2:ba:1e:12:5c > Slave queue ID: 0 > > Slave Interface: p6p2 > MII Status: up > Speed: 10000 Mbps > Duplex: full > Link Failure Count: 0 > Permanent HW addr: 90:e2:ba:1e:12:5d > Slave queue ID: 0 > > Any suggestions and help are much appreciated! > > Thanks! > Nick > _______________________________________________ > CentOS mailing list > CentOS at centos.org > http://lists.centos.org/mailman/listinfo/centos >