# modinfo ixgbe filename: /lib/modules/2.6.32-431.el6.x86_64/kernel/drivers/net/ixgbe/ixgbe.ko version: 3.15.1-k license: GPL description: Intel(R) 10 Gigabit PCI Express Network Driver author: Intel Corporation, <linux.nics at intel.com> srcversion: B390E9D9904338B52C2E361 I have updated this to 3.18.7-1 as well, same results # ifconfig bond1 |grep error RX packets:4476995 errors:6940 dropped:0 overruns:0 frame:6940 TX packets:2130564 errors:0 dropped:0 overruns:0 carrier:0 # cat /proc/net/bonding/bond1 Ethernet Channel Bonding Driver: v3.6.0 (September 26, 2009) Bonding Mode: adaptive load balancing Primary Slave: None Currently Active Slave: p6p1 MII Status: up MII Polling Interval (ms): 100 Up Delay (ms): 0 Down Delay (ms): 0 Slave Interface: p6p1 MII Status: up Speed: 10000 Mbps Duplex: full Link Failure Count: 0 Permanent HW addr: 90:e2:ba:1e:12:5c Slave queue ID: 0 Slave Interface: p6p2 MII Status: up Speed: 10000 Mbps Duplex: full Link Failure Count: 0 Permanent HW addr: 90:e2:ba:1e:12:5d Slave queue ID: 0 Any suggestions and help are much appreciated! Thanks! Nick