That is a software RAID controller, only works if you install HP's driver first. Or switch to AHCI mode for individual disks. See this article https://access.redhat.com/site/articles/118133 Thomas On 03/03/2014 11:57 AM, Kenny Noe wrote: > Also I have the FBWC module installed to allow RAID 5. > > --Kenny > > > On Mon, Mar 3, 2014 at 2:52 PM, Kenny Noe <knoe501 at gmail.com> wrote: > >> Here is the system. >> >> >> HP ML350e G8 servers. They use the HP Dynamic Smart Array B120i raid >> controllers. >> >> Thanks! --Kenny >> >> >> On Mon, Mar 3, 2014 at 2:07 PM, John R Pierce <pierce at hogranch.com> wrote: >> >>> On 3/3/2014 10:54 AM, Kenny Noe wrote: >>>> OK so what am I doing wrong?? Apparently anaconda is still reading 4 >>>> independent disk instead of a single 3 TB "disk". How do I get the >>>> installer to recognize the single RAID disk? >>> >>> not going to read the whole thread, what sort of raid controller does >>> this system have? >>> >>> >>> >>> -- >>> john r pierce 37N 122W >>> somewhere on the middle of the left coast >>>