Well shoot! Thanks for the link. Definitely explains allot! I'm going to update the box with the latest HP SPP and double check the updated driver is available. With this RAID controller and 4x 1TB are there any recommendations on the best way to install CentOS? Should I skip the controller, config disk as JBOD and RAID from there? I'd like to get the OS on a RAID but should I just build the OS on one disk and then RAID the remaining three? Sooo many choices.... Just need a box that is stable, has some type of redundancy and plenty of space. Thanks to all for your advice. I appreciate the help and guidance. Respectfully, --Kenny On Mon, Mar 3, 2014 at 3:04 PM, Thomas Eriksson < thomas.eriksson at slac.stanford.edu> wrote: > That is a software RAID controller, only works if you install HP's > driver first. Or switch to AHCI mode for individual disks. > > See this article https://access.redhat.com/site/articles/118133 > > Thomas > > On 03/03/2014 11:57 AM, Kenny Noe wrote: > > Also I have the FBWC module installed to allow RAID 5. > > > > --Kenny > > > > > > On Mon, Mar 3, 2014 at 2:52 PM, Kenny Noe <knoe501 at gmail.com> wrote: > > > >> Here is the system. > >> > >> > >> HP ML350e G8 servers. They use the HP Dynamic Smart Array B120i raid > >> controllers. > >> > >> Thanks! --Kenny > >> > >> > >> On Mon, Mar 3, 2014 at 2:07 PM, John R Pierce <pierce at hogranch.com> > wrote: > >> > >>> On 3/3/2014 10:54 AM, Kenny Noe wrote: > >>>> OK so what am I doing wrong?? Apparently anaconda is still reading 4 > >>>> independent disk instead of a single 3 TB "disk". How do I get the > >>>> installer to recognize the single RAID disk? > >>> > >>> not going to read the whole thread, what sort of raid controller does > >>> this system have? > >>> > >>> > >>> > >>> -- > >>> john r pierce 37N 122W > >>> somewhere on the middle of the left coast > >>> > _______________________________________________ > CentOS mailing list > CentOS at centos.org > http://lists.centos.org/mailman/listinfo/centos >