On Tue, June 23, 2015 4:24 pm, m.roth at 5-cent.us wrote: > m.roth at 5-cent.us wrote: >> I just updated a server that's running CentOS 7. I do have elrepo >> enabled, >> because this Rave computer has four early Tesla cards. >> >> It won't boot. Nor can I get it to boot with either of the other two >> kernels, and I'll be the one that worked was erased. >> >> *Once* it complained that it couldn't fsck the large filesystem (IIRC, >> it's XFS). The other four-five times, I get pNFS something Dependency, >> failed, systemd freezing execution. >> >> So far, I'm googling, and not finding anything like this. Has anyone run >> into this, or have any suggestions? >> >> If I could get back to the fsck failure, I could at least tell it to >> ignore /dev/sdb.... >> > > This is more complex... I have two drives in this system. I've got one > that holds the CentOS 7 install, and one with 6.6. The one with the 7 is > in hot swap bay 1, while the other's in bay 2. With both of them in there, > it goes to boot off what I would expect to be enumerated as hd1; instead, > it seems to see it as hd0. > > When I pull out the drive with 6, 7 boots just fine. The drive with 6, of > course, has grub, while the one with 7 has grub2. > > Any ideas as to how I can get it to work with the correct drive? > Of course this is stupid, but I would just tell grub2 write bootsector on the other drive. You may need to boot off DVD and chroot into CentOS7 for that. But think it over first as _my_ brain has melted and doesn't work today. Valeri ++++++++++++++++++++++++++++++++++++++++ Valeri Galtsev Sr System Administrator Department of Astronomy and Astrophysics Kavli Institute for Cosmological Physics University of Chicago Phone: 773-702-4247 ++++++++++++++++++++++++++++++++++++++++