It is in AHCI, never was changed On 19:26, Thu, Nov 19, 2015 Gordon Messmer <gordon.messmer at gmail.com> wrote: > On 11/19/2015 12:54 AM, Birta Levente wrote: > > I tried today morning on RHEL too ... > > The ISDCT tool does not work on supported OS neither > > I think everyone focused on your problem with the vendor, who didn't > support your OS, and ignored the fact that the tool worked when the > drives were connected to a secondary controller. The OS never caused a > problem for the tool, only for the vendor's support staff. > > So, again, check your BIOS settings and make sure the SATA ports are in > the standard AHCI mode. > _______________________________________________ > CentOS mailing list > CentOS at centos.org > https://lists.centos.org/mailman/listinfo/centos >