I assume you are using one of the boards described here? http://www.intel.com/support/services/smartconnect/sb/CS-033108.htm On 11/19/2015 10:43 AM, Birta Levente wrote: > It is in AHCI, never was changed > > On 19:26, Thu, Nov 19, 2015 Gordon Messmer <gordon.messmer at gmail.com> wrote: > >> On 11/19/2015 12:54 AM, Birta Levente wrote: >>> I tried today morning on RHEL too ... >>> The ISDCT tool does not work on supported OS neither >> >> I think everyone focused on your problem with the vendor, who didn't >> support your OS, and ignored the fact that the tool worked when the >> drives were connected to a secondary controller. The OS never caused a >> problem for the tool, only for the vendor's support staff. >> >> So, again, check your BIOS settings and make sure the SATA ports are in >> the standard AHCI mode. >> _______________________________________________ >> CentOS mailing list >> CentOS at centos.org >> https://lists.centos.org/mailman/listinfo/centos >> > _______________________________________________ > CentOS mailing list > CentOS at centos.org > https://lists.centos.org/mailman/listinfo/centos > -- -=- Sent my from my laptop, may not be able to respond timely