[CentOS] 答复: 答复: How to configure VLAN in CentOS7
gordon.messmer at gmail.com
Tue Apr 19 15:56:50 UTC 2016
On 04/18/2016 11:19 PM, liyulei wrote:
> I am deploying Liberty Neutron, according the official document, there are
> two NIC at least, but my physical machine has only one. Someone suggested me
> I could create a vlan interface, then everything would be ok. Until now,
> though I created the vlan interface, it can't attach to the Internet.
> Could other methods created virtual interface instead of vlan interface?
I can't give you an authoritative answer, but... You might be able to
deploy the openstack components that you need using VLANs, but you have
to understand how 802.1q tagging works.
Since you don't have access to the switch, when you create a tagged
VLAN, you will only be able to communicate on that interface with other
systems where you have created an identically tagged interface, and only
if your switch supports jumbo packets and doesn't try to manage the
I'm guessing that you don't have access to your router since you don't
have access to your switch. In that case, you should revert ifcfg-eno1
to its original state. You can't put the subnet to which your default
gateway is attached on a tagged interface. With that file in its
original state, you can create a new, tagged interface with a different
subnet and no GATEWAY specified. Then, create an interface with the
same tag number on a different computer, and assign another address in
the same (new) subnet. Test communication between those two addresses.
Specifically, test streaming data to make sure that full-sized packets
More information about the CentOS