Re: [Arm-dev] Gigabyte MP30-AR0, nomodeset, and retaining output on serial console

I can confirm that adding:

earlycon=uart8250,mmio32,0x1c020000 console=ttyS0,115200 console=tty0

produces exactly the desired results - everything appears on the serial port, and as much as usual also appears on the VGA output.

Gordan

On 18/03/16 08:11, Chuong Tran wrote:

Hi,

You can add "earlycon=uart8250,mmio32,0x1c020000" to see how far the kernel boot on serial console can go.

Also, make sure to say Y to CONFIG_SERIAL_8250 & relevant config in your kernel .config.

Best regards,

Chuong.

On Fri, Mar 18, 2016 at 2:49 PM, Michael Howard <mike@dewberryfields.co.uk mailto:mike@dewberryfields.co.uk> wrote:

On 18/03/2016 03:18, Chuong Tran wrote:

    Hi Gordan,

    If you want to retain the output on serial console, please add
    kernel command "console=ttyS0,115200" at the grub config.
    If you want to see the kernel boot at both serial and vga, add
    "console=tty0" (for vga) along side with "console=ttyS0,115200".
    The output from VGA will come after kernel configure the video card.


I use this setting ("console=ttyS0,115200 console=tty0") but output
is not retained on the serial console. Maybe this is kernel specific.

--
Mike Howard


_______________________________________________
Arm-dev mailing list
Arm-dev@centos.org <mailto:Arm-dev@centos.org>
https://lists.centos.org/mailman/listinfo/arm-dev

---

Arm-dev mailing list Arm-dev@centos.org https://lists.centos.org/mailman/listinfo/arm-dev