I am starting on a fresh install of the 1611 Cubietruck image. This time I am running on a Cubietruck, not a Cubieboard2.
I have the cubietruck uboot on a mSD card and the image installed on a Kingston 240Gb SSD drive.
I boot up, log in with root with the default password. All I do is change /boot/extlinux/extlinux.conf with:
sed -i -e "s/enforcing=0/enforcing=1/w /dev/stdout" /boot/extlinux/extlinux.conf
Note that https://wiki.centos.org/SpecialInterestGroup/AltArch/Arm32 is wrong saying:
If you want to switch to enforcing mode, you'll have so to first modify the following files /etc/sysconfig/selinux : change from "permissive" to "enforcing"
* rpi2/rpi3 : /boot/cmdline.txt: change "enforce=0" to "enforcing=1" * other image/board[s]: /boot/extlinux/extlinux.conf : change the "enforce=0" to "enforce=1"
It is enforcing=0 on the Cubietruck image. Then:
touch /.autorelabel
and
reboot
I get the log message:
[ 18.453896] brcmfmac: brcmf_sdio_htclk: HT Avail timeout (1000000): clkctl 0x50
*** Warning -- SELinux targeted policy relabel is required. *** Relabeling could take a very long time, depending on file *** system size and speed of hard drives. [ 54.365478] random: nonblocking pool is initialized Warning: Skipping the following R/O filesystems: /sys/fs/cgroup
Then after some time, it goes through a shutdown, reboots and comes back to this state. Then reboots again. I have tried this twice.
Next I will try on my Cubieboard2, that I will have to take down from its testing position for this test. If it still fails, I will try a HD. These commands have worked for my on the C2 with a HD and a mSD card. I don't recall if I have tried them on a CT.
But any thoughts are appreciated!
thanks