Take the fedora-arm-installer rpm and install it and use it!
The image you work from MUST have /usr/share/uboot
The list of supported boards is in the board.d directory in fedora-arm-installer.
Lots of boards supported.
But NOT RPi2!
I have to sign off now.
take a look at:
https://fedoraproject.org/wiki/Architectures/ARM/F23/Installation
Copy that pretty much wholesale until the boot config portion. Add a note that the centos-arm-installer does not support the RPi2, and see below for manual install.
On 12/18/2015 03:59 PM, Robert Moskowitz wrote:
Take the fedora-arm-installer rpm and install it and use it!
The image you work from MUST have /usr/share/uboot
The list of supported boards is in the board.d directory in fedora-arm-installer.
Lots of boards supported.
But NOT RPi2!
I have to sign off now.
Arm-dev mailing list Arm-dev@centos.org https://lists.centos.org/mailman/listinfo/arm-dev
-
Robert Moskowitz