On 2020-05-15 16:12, Fabian Arrotin wrote:

On 15/05/2020 05:33, Sam via Arm-dev wrote:

...

hi i couldnt find a search tool for the mailing list, so apologies if it has been already discussed but i cannot find a howtofor the orange pi pc2.

i see it as a supported device but not sure what i need to do to get it to boot.

i used rufus and install OS and tried:

CentOS-Userland-7-aarch64-generic-Minimal-2003-sda.raw.xz CentOS-Userland-7-armv7hl-generic-Minimal-2003-sda.raw.xz CentOS-Userland-7-armv7hl-RootFS-Minimal-2003-sda.raw.xz

and none of them boot.

I am assuming i am to load the specific uboot for the said device but not sure how?

https://wiki.centos.org/SpecialInterestGroup/AltArch/armhfp#How_to_Install_C... has all the pointers for the uboot setup after you've used dd to put the image on sd card

So as you can see, there are two examples as some boards just need one .bin for uboot and some need two, so it depends on your board, but following the instructions about having the uboot-images-armv7 pkg installed/exploded on disk should give you pointers about your board

---

Arm-dev mailing list Arm-dev@centos.org https://lists.centos.org/mailman/listinfo/arm-dev

Thanks Fabian,

I managed to get it to work, so good to be on an (old friend) RPM based OS again.

FWIW, i also took these two as reference points on further research with the latter i used the sp1 precompiled binary from there.

https://wiki.archlinux.org/index.php/Orange_Pi https://gitlab.com/vinibali/orangepi_uboot/-/tree/master

Cheers, Sam.