Hi,
Order of console kernel arguments matters, as far as I know, output
goes to the last console.
console=tty0 console=ttyS0,115200n8
-> boot output to ttyS0
console=ttyS0,115200n8 console=tty0
-> boot output to tty0
Maybe this could be the reason why do not see output ?
--
Best Regards
Markus
On 11 Jun 2010, at 01:08, Lars Hecking wrote:
>
>> IIRC you're connected to the serial console of the guest, so if your
>> software isn't setup to use the serial port nothing will happen (or
>> output only garbage).
>
> I found instructions here
>
>
http://blog.zelut.org/2010/05/05/configure-serial-console-access-on-centos-5...
>
> and it kinda works - I can see the start of the boot process, and once
> finished, I can login via serial console, but do not see the boot
> output.
> Still, better than nothing.
>
>
>
> ---------------------------------------------------------------
> This message and any attachments may contain Cypress (or its
> subsidiaries) confidential information. If it has been received
> in error, please advise the sender and immediately delete this
> message.
> ---------------------------------------------------------------
>
> _______________________________________________
> CentOS-virt mailing list
> CentOS-virt@centos.org
>
http://lists.centos.org/mailman/listinfo/centos-virt