On 01/26/2016 01:51 PM, Robert Nichols wrote:
Anyone managed to get a Windows 10 guest running well under qemu/kvm? I can get it up and running, but there is a major issue with losing use of the mouse, plus my display resolution is stuck at 1024x768.
The mouse will work for a short time (a few seconds to a few minutes), but then stops responding. That's with the mouse coming in as the recommended QEMU tablet device. I can assign a USB mouse to the guest as a USB host device, but it also stops responding after a short time. At least with the USB mouse I can remove it from the guest and then reassign it again. That gives me use of the mouse, but again only for a short time. Trying run Windows 10 from just a keyboard is an exercise in frustration.
I can't get Windows 10 to believe that any screen resolution besides 1024x768 is available. That's the case both with VNC/vga and Spice/qxl. This is in contrast with Windows 7, which offers a good selection of resolutions with VNC/vga.
Well, I got the mouse problem solved. I finally ran across http://unix.stackexchange.com/questions/131942/qemu-2-0-windows-guest-mouse-stops-working-vnc-when-using-usb-passthrough and followed the instructions to go into the power settings for the tablet device and remove the check mark on "Allow the computer to turn off this device to save power." Presto! No more mouse problems.
I've still got to figure out how to get a display bigger than 1024x768, but fiddling with that should be a lot easier with a working mouse.