Hello all,

I have been running xen for a while now with two interfaces: dummy0 for host only communication, and eth0 for the outside network.

my script looks like this: (/etc/xen/scripts/network-bridge-more) ------------------------------------------------------------------ #! /bin/sh

dir=$(dirname "$0") "$dir/network-bridge" "$@" vifnum=0 netdev=dummy0 bridge=xenbr0 "$dir/network-bridge" "$@" vifnum=1 netdev=eth0 bridge=xenbr1 ------------------------------------------------------------------

now i have a newer setup where eth0 and eth1 are bonded.

If i change eth0 in the above script to bond0 it messes up the bond completely and stops working.

I have use /etc/xen/scripts/network-bridge-bonding, and that works, but then I can only have one virtual network for my domU

I have tried this: ------------------------------------------------------------------ #! /bin/sh

dir=$(dirname "$0") "$dir/network-bridge" "$@" vifnum=0 netdev=dummy0 bridge=xenbr0 "$dir/network-bridge-bonding" "$@" vifnum=1 netdev=bond0 bridge=xenbr1 ------------------------------------------------------------------

but that also does not work. It also messes up my bond.

Any tips would be greatly appreciated.

Kind regards, Coert