I have seen those documents, I did not see anything that indicates how _automatic_ bridge configuration could be enabled with xl.
For my specific set up I have two bridges (xenbr0 -> peth0 & xenbr1 -> peth1). If I have to configure this manually with ifcfg scripts I will, but if an automatic method is provided or is possible with xl I'd prefer to use that.
-Gene
On Thu, Jan 29, 2015 at 4:07 AM, Lars Kurth lars.kurth.xen@gmail.com wrote:
Gene, I think you should find the answers in
page)
http://wiki.xenproject.org/wiki/Migration_Guide_To_Xen4.1+
http://wiki.xenproject.org/wiki/Network_Configuration_Examples_%28Xen_4.1%2B... http://wiki.xenproject.org/wiki/Network_Configuration_Examples_(Xen_4.1+)
be relevant If not, circle back to the list and I am sure someone else will be able to answer Regards Lars
On 29 Jan 2015, at 08:39, Gene gh5046@gmail.com wrote:
I normally use the network-script parameter in the '/etc/xen/xend-config.sxp' configuration file to configure network bridges. However, the latest release of Xen4CentOS (which comes with Xen 4.4.1) has xend disabled by default.
Can I continue to use network-script without xend? If not what is the recommended method for automatically configuring network bridges with the latest release of Xen4CentOS?
I know I can just enable xend to continue using this script, but since Xen 4.5 is apparently dropping xend altogether I figure I should change my standard configuration starting now.
Thanks in advance for your time.
-Gene
CentOS-virt mailing list CentOS-virt@centos.org http://lists.centos.org/mailman/listinfo/centos-virt
CentOS-virt mailing list CentOS-virt@centos.org http://lists.centos.org/mailman/listinfo/centos-virt